window frame question - Trail-Gear On-Line Forum

DPQ · #1 10-20-2009, 10:20 AM

Frames on both sides are spot welded to the door on the 74 FJ40 that I am working on. (only welded on outside area) I am getting ready to replace the glass and it looks like these frames are supposed to be removeable (slide up and out) of the door.
Is this weld "factory" ?
If not, I guess I need to grind it down to get the window frame up and out to replace the glass and the regulator ?

Thanks,

BT

John Gabriel · #2 10-20-2009, 10:40 AM

That weld does not look factory to me but i do not own an fj.

jackrista · #3 10-20-2009, 05:03 PM

Quote:

Originally Posted by John Gabriel

That weld does not look factory to me but i do not own an fj.

x2

DPQ · #4 10-20-2009, 06:36 PM

ok, thanks gents
will grind it off tomorrow

DPQ · #5 10-26-2009, 12:17 PM

Now I know why prev owner made the weld. The door panel is fatigued from an impact and has popped out about 1/2" now that it is back together. Where the two door panels overlap (under the vent window) I might be able to install a pop rivet there ... Waiting on new screws then I will look at it again.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)